Arduino Interfacing With LCD(16x02) Without Potentiometer

All, today i gonna to share how Arduino connected to LCD(16x02).

LCD 16x02 means 16 character in 2 rows.


Connection between LCD and UNO

Code:

#include <LiquidCrystal.h>
int Contrast=75;
LiquidCrystal lcd(12, 11, 5, 4, 3, 2);

void setup()
{
    analogWrite(6,Contrast);
     lcd.begin(16, 2);
}
     void loop()
{
     lcd.setCursor(0, 0);
     lcd.print("ITS WORK");

    lcd.setCursor(0, 1);
     lcd.print("WELL DONE");
}

Comments

L298N motor with Ultrasonic Sensor using Can Bus MCP2515

Today, I will share the project where we use 2x Arduino where each Arduino act as Transmitter to measure a distance using Ultrasonic sensor and Receiver controlling L98N motor driver. Ultrasonic Sesnor L298N Motor Driver Two output Motor Driver with Enable pin for both Motor. Requirement: 1. 2x Arduino 2. 2x MCP2515 CAN module 3. L298N Motor Driver 4. Ultrasonic Sensor 5. 12V battery 6. Download NewPing, SPI and mcp2515 into Arduino. Instruction: 1. Connect Arduino Nano to Ultrasonic sensor. 2. Connect Arduino Nano to MCP2515(1) through SPI connection. 3. Connect MCP2515(1) with MCP2515(2) using CAN-H and CAN-L wire. 4. Connect MCP2515(2) to Arduino Uno through SPI connection. 5. Connect Arduino Uno with Motor L298N. Code: Transmitter: #include <NewPing.h> #include <SPI.h> //Library for using SPI Communication ...

Explanation Of CAN Bus

Modern car today like an a small computer where everything is connected each other in the same network. It have a few network normally used in car like a Controller area network(CAN), Local Interconnect network(LIN), Media Oriented System Transport(MOST) and FlexRay. The most used is CAN Bus . CAN BUS allow ECU communicate each other without host computer. Before, in Old car, the number of ECU is less because low demand on the technology. Today, with current technology, a modern Car have a more than 70 ECU. How it looks like if everything is connected using old way? Hard wire? That the reason in mid-1980, Bosch design CAN Bus to reduce costs and complexity inside the vehicle. CONTROLLER AREA NETWORK(CAN) CAN is a serial communication bus where allow ECU in car communicate each other robustly with maximum bit rate of 1Mb/s for high speed. It is a mist suitable for systems where a small amount information needs to be exchange. Instead of automo...

Technology In Electronic

Search This Blog